Photographs below of a Porcelain tiled shower that had been installed at a house in Cheshunt the year before. The tiles were actually dark grey textured porcelain tile but hard water in the area had left very noticeable water stains and limescale deposits that were proving hard to remove with general cleaning.
Hardwater is basically water with a high mineral content which are historically recognised as being good for you, however it’s not so good for the bathroom where the minerals are left behind when the water evaporates.
On the initial visit to survey the tiles we ran a test clean on a small area to ensure we could return the tile back to its as new condition. All went well, and the customer booked us in to return later to complete the work.
Removing Limescale from Porcelain Shower Tiles
Work began by giving the shower tiles an initial clean with Tile Doctor Aqua-Pro which was worked into grout lines with detail brushes and a burnishing pad for the tile surface. This process removed all the Limescale and water marks.
A second clean was then carried out with Tile Doctor Duo-Clean which is a fast-effective double action cleaning solution that can remove mould and blackspots from grout and silicone. The solution was sprayed on the shower room floor and walls and left to soak in before being worked in with a stiff brush.
The shower tiles were then rinsed with a steam cleaner to remove any trace of product and then buff the tiles with a hand-held white buffing pad to bring up their appearance.
To give it a neat waterproof finish we stripped out the old silicone sealant from around the base of the shower and replaced with new mould resistant silicone.
The shower took a whole day to complete but I think you will agree has been transformed by the process.
Reducing the Impact of Hard Water
To minimise the impact of hard water some shower units will keep the shower running at a gradually decreasing temperature immediately after use. This has the effect of rinsing off the deposits before evaporation has chance to occur. Personally, we recommended you spray the shower tiles with Tile Doctor Aqua-Pro after use, this product is a bathroom tile cleaner that is ideal for the regular cleaning of all types of internal porcelain/ceramic bathroom/wet room tiles. Apply by lightly spraying a dilution of the cleaner and wipe over then water rinse and dry buff to finish.
Source: Porcelain Tile Cleaning and Restoration Service in Hertfordshire